Disable Source Routed Packet Acceptance
Scanned 9/3/2026
Install to Claude Code
npx -y skills add CyberStrikeus/CyberStrike --skill cis-ubuntu1204-v110-7-2-1 --agent claude-codeInstalls into .claude/skills of the current project.
Are you the author of Cis Ubuntu1204 V110 7 2 1?
Add the live security badge to your README — it updates automatically with every re-scan.
[](https://www.skillsdirectory.com/skills/cyberstrikeus-cis-ubuntu1204-v110-7-2-1)More formats (shields.io, HTML) on the badges page.
---
name: cis-ubuntu1204-v110-7-2-1
description: "Disable Source Routed Packet Acceptance"
category: cis-os-hardening
version: "1.1.0"
author: cyberstrike-official
tags: [cis, ubuntu, 12.04, linux, networking, source-routing, sysctl, host-router]
cis_id: "7.2.1"
cis_benchmark: "CIS Ubuntu 12.04 LTS Server Benchmark v1.1.0"
tech_stack: [ubuntu, linux]
cwe_ids: []
chains_with: []
prerequisites: []
severity_boost: {}
---
# 7.2.1 Disable Source Routed Packet Acceptance (Scored)
## Profile Applicability
- Level 1
## Description
In networking, source routing allows a sender to partially or fully specify the route packets take through a network. In contrast, non-source routed packets travel a path determined by routers in the network. In some cases, systems may not be routable or reachable from some locations (e.g. private addresses vs. Internet routable), and so source routed packets would need to be used.
## Rationale
Setting `net.ipv4.conf.all.accept_source_route` and `net.ipv4.conf.default.accept_source_route` to 0 disables the system from accepting source routed packets. Assume this server was capable of routing packets to Internet routable addresses on one interface and private addresses on another interface. Assume that the private addresses were not routable to the Internet routable addresses and vice versa. Under normal routing circumstances, an attacker from the Internet routable addresses could not use the server as a way to reach the private address servers. If, however, source routed packets were allowed, they could be used to gain access to the private address systems as the route could be specified, rather than rely on routing protocols that did not allow this routing.
## Audit Procedure
### Using Command Line
Perform the following to determine if accepting source routed packets is disabled.
```bash
/sbin/sysctl net.ipv4.conf.all.accept_source_route
/sbin/sysctl net.ipv4.conf.default.accept_source_route
```
## Expected Result
```
net.ipv4.conf.all.accept_source_route = 0
net.ipv4.conf.default.accept_source_route = 0
```
## Remediation
### Using Command Line
Set the `net.ipv4.conf.all.accept_source_route` and `net.ipv4.conf.default.accept_source_route` parameters to 0 in `/etc/sysctl.conf`:
```bash
net.ipv4.conf.all.accept_source_route=0
net.ipv4.conf.default.accept_source_route=0
```
Modify active kernel parameters to match:
```bash
/sbin/sysctl -w net.ipv4.conf.all.accept_source_route=0
/sbin/sysctl -w net.ipv4.conf.default.accept_source_route=0
/sbin/sysctl -w net.ipv4.route.flush=1
```
## Default Value
Source routed packet acceptance is enabled by default.
## References
- CIS Ubuntu 12.04 LTS Server Benchmark v1.1.0
## Profile
Level 1 - Scored

Is this your skill, or is something wrong with this listing? Request removal or report an issue. Author removals are honored within 72 hours.
No comments yet. Be the first to comment!