All authors
Claude Skills by iot-forge
github.com/iot-forge9 skills2 installs30 views
- New Device SkillBuild or update an M5Stack hardware skill in this marketplace — a Controller (a board that runs firmware, like Core2 or AtomS3), a Unit (a peripheral you drive from a Controller, like a ToF sensor or a relay), or a Chip (an Espressif SoC capability layer, like esp32-c6). Use whenever adding a new board/unit/chip to this repo, correcting an existing skill, deciding whether something warrants its own skill versus a section in an existing one, or figuring out where a piece of content belongs (bo...Votes: 0GitHub stars: 2
- Cap Lora 1262Hardware reference and firmware helper for the M5Stack Cap LoRa-1262 (SKU U214) — a snap-on cap for the Cardputer Adv (K132-Adv) and CardputerZero that carries a Semtech SX1262 sub-GHz LoRa radio (868–923 MHz, +22 dBm TX, external RP-SMA antenna) and an ATGM336H-6N GNSS receiver (GPS/QZSS/BeiDou/Galileo/GLONASS, UART @ 115200 8N1). Use whenever a user is writing, debugging, or wiring firmware for the Cap LoRa-1262 — LoRa TX/RX with RadioLib, GNSS parsing with TinyGPSPlus, SPI/GPIO/UART pin ma...Votes: 0GitHub stars: 2
- Cardputer AdvHardware reference and development helper for the M5Stack Cardputer Adv (also written Cardputer-ADV, product code K132-Adv) — a pocket ESP32-S3 computer with a 56-key keyboard, 1.14" screen, BMI270 IMU, and ES8311 audio codec. Use this skill whenever the user is writing, debugging, or planning firmware for a Cardputer Adv, or asks about its pinout, keyboard (TCA8418), IMU (BMI270), audio codec (ES8311), display (ST7789V2), Grove/EXT ports, battery behavior, or how to set it up in Arduino IDE,...Votes: 0GitHub stars: 2
- Core2Hardware reference and development helper for the M5Stack Core2 family — a 2.0" touchscreen ESP32 (classic, Xtensa LX6) Controller built around an AXP192 power management IC, ILI9342C display, FT6336U capacitive touch, BM8563 RTC, and (on original/1.1/1.3 revisions) an MPU6886 or BMI270 IMU. Covers the plain Core2 (v1.0/v1.1, v1.3) and the Core2 For AWS variants (For AWS, For AWS v1.3), which add an ATECC608B hardware crypto chip for AWS IoT device authentication, a 10-LED SK6812 RGB ring, an...Votes: 0GitHub stars: 2
- Tab5Hardware reference and development helper for the M5Stack Tab5 (product code C145) — an ESP32-P4-based 5" touchscreen IoT/industrial terminal with an ESP32-C6 wireless co-processor, MIPI-DSI display, MIPI-CSI camera, ES8388 audio codec, BMI270 IMU, RX8130CE RTC, RS485, and a removable NP-F550 battery. Use this skill whenever the user is writing, debugging, or planning firmware for a Tab5, or asks about its pinout, display/touch (GT911/ILI9881C or ST7123/ST7121), camera (SC2356), audio (ES8388...Votes: 0GitHub stars: 2
- Esp32 C6Chip-level ESP-IDF capability reference for the ESP32-C6 SoC (single-core RISC-V HP core + RISC-V LP core, WiFi 6 + BLE 5.3 + Thread/Zigbee) — what the chip can do, distinct from any board's wiring. Use when a user wants to exploit ESP32-C6 hardware — WiFi 6/BLE/802.15.4 radio coexistence (Thread Border Router, Zigbee gateway, Matter endpoints, why it's time-division not simultaneous), the LP core (a real always-available RISC-V coprocessor, not a restricted ULP-FSM), RMT/LEDC/I2S/ADC/PCNT/MC...Votes: 0GitHub stars: 2
- Esp32 P4Chip-level ESP-IDF capability reference for the ESP32-P4 SoC (dual-core RISC-V HP cores + a RISC-V LP core) — what the chip can do, distinct from any board's wiring. Use when a user wants to exploit ESP32-P4 hardware — MIPI-CSI/DSI with the on-chip ISP, hardware JPEG encode/decode, hardware H.264 encode, PPA/2D-DMA image acceleration, the LP core and its own peripherals, USB HS OTG vs FS OTG vs USB-Serial-JTAG, TWAI/CAN, Ethernet MAC, SDIO host, in-package PSRAM up to 32MB, HP-core task pinni...Votes: 0GitHub stars: 2
- Esp32 S3Chip-level ESP-IDF capability reference for the ESP32-S3 SoC (Xtensa LX7 dual-core) — what the chip can do, distinct from any board's wiring. Use when a user wants to go beyond basic Arduino sketches and exploit ESP32-S3 hardware — RMT (IR/WS2812/custom protocols), LEDC (PWM), I2S (audio), ADC/touch sensing, PCNT (encoders), MCPWM (motor control), TWAI/CAN, SDMMC/SD-SPI, native USB OTG vs the USB-Serial-JTAG controller, sleep modes and wake sources, ULP-FSM/ULP-RISC-V coprocessors, octal/quad...Votes: 0GitHub stars: 2
- Esp32Chip-level ESP-IDF capability reference for the classic ESP32 SoC (dual-core Xtensa LX6) — what the chip can do, distinct from board wiring. Covers the ESP32-D0WDQ6-V3 / ESP32-D0WD-V3 / ESP32-D0WDR2-V3 die family used in ESP32-WROOM-32 and ESP32-WROVER modules. Use for RMT (IR/WS2812), LEDC (PWM), I2S (audio/parallel camera), ADC/DAC/touch (incl. ADC2-vs-WiFi conflict), PCNT, MCPWM, TWAI/CAN, SDMMC host + SDIO slave, the deprecated Hall sensor, ULP-FSM, deep sleep/hibernation, dual-core task ...Votes: 0GitHub stars: 2